Industry Indices
← Research & analysis
Court & competition equipment

Research

Original research analysis

AO Buying Guide | Field-event measuring rods, landing pins and distance markers: range first, then temporary versus fixed marks

Nine small Taishan field-event items in two groups: measuring rods by top of range, with graduations and verification not stated; pins, boards and flags as temporary marks and distance markers as fixed ones, where BZH13 and BZH14 carry identical page figures.

Record date (source acquisition dates below) Nov 9, 2026 · Original editorial and source-scope review

Scope

AO Ranking buying guide based on sourced manufacturer statements already in the library; not a test, ranking or certification conclusion.

Measuring rods: range first

ModelUseRange or size (publisher)Mass (publisher)Material
TG17High-jump measuring rod1200-2500 mm2 kgAluminium alloy
CHG191Pole-vault measuring rod2000-6400 mm4 kgAluminium alloy
JS15Hurdle measuring gauge1200 mm0.6 kgStainless steel

AO Ranking view: check first that the top of the range is high enough, then the graduations. All three pages give a range or length, but none states the smallest graduation or whether the rod is metrologically verified; for competition use, add both to the technical requirements. A separate page for measuring tapes CL11-CL16 has misaligned table columns (a steel tape listed as fibre, for example), so the library does not take figures from it for now.

3 section citations

Landing and distance markers: two kinds

ModelUseSpecification (publisher)Mass (publisher)Material
TQ1120Landing-point marker pin750 mm highAbout 0.5 kgWelded steel tube
TQ1145Marker or record flag240 mm diameter x 700 mmAbout 3 kgSteel tube, silk
TQ2139/1Near-distance landing board200 mm diameter x 548 mmNot listedSteel
TQ2139Far-distance landing board300 mm diameter x 848 mmNot listedSteel
BZH14Shot-put distance marker400 mm8 kgFibreglass
BZH13Javelin and discus distance marker400 mm8 kgFibreglass

AO Ranking view: buy this group as two kinds, temporary landing marks and fixed distance markers. Pins and boards are what officials use to mark a landing on the spot, so mass and how they go into the ground matter. Distance markers sit beside the landing sector; BZH14 and BZH13 have identical size, mass and material on their pages and are told apart only by 'for shot put' and 'for javelin and discus', so the order should state which distance figures go on each marker.

6 section citations

What this guide leaves out

  • The run-up marker (1017), long-jump distance board (1016) and sand rake (1018) pages give names only and are left out.
  • Rod graduations, verification certificates and the figures printed on distance markers are not stated on the pages.
  • No prices, sales or rankings. All figures are publisher statements; AO Ranking has not tested them.
1 section citations

Sources & retrieval dates

Documented source dates

  1. Source acquisition record
  2. Source acquisition record